Previous Thread
I am having the same problem. Did you find out how to remove the PSU?
My IQ770 just went out with a fizzle. No power is being supplied and I'm pretty sure it's the power unit failure. I know where to get the replacement unit(on eBay) but I don't know how to remove it. I've succeded in removing the rear panel and located two screws that holds the PSU but even after removing it, I can't seem to lift-out the PSU. I could jiggle it and it's loose and jiggles but I just can't seem to lift it. Is it being held by a rail or something? Anyone have removed/replaced their PSU? Any help will be appreciated. I'm getting desperate !!!!! It's office computer and need it urgently. Thanks in advance for any help.
December 5, 2010 8:58 AM
2 screws holding it in left and right. remove. then use force and bang it toward towards the monitor. there are brackets underneath that hold it in place
Add Your Reply
Sponsored Links
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
This community site, TouchSmartDevZone.com (including its terms of use, privacy policy and content), is offered by and managed by Capable Networks LLC, not by Hewlett-Packard Company (HP). HP is not responsible for the performance of this community site or for any content posted on the site nor is HP liable for any damages or losses caused or alleged to have been caused by the use this Capable Networks community site. The Community Site is intended for TouchSmart users in the United States and Canada.
View unverified member's comment - posted by npicklo