OUR NETWORK:MediaSmart Home Sansa Community Explore3DTV TechLore RoboCommunity Dijit Community About UsAdvertiseContact Us
Previous Thread | Next Thread

 
Learn about scoring Forum's Raw Score: 109506.0
April 12, 2010 10:23 AM
Rating (0 votes)
  • 1
  • 2
  • 3
  • 4
  • 5
Rate This!

Member Avatar

Tomas

Member
Joined: 09/09/2009

Has anyone managed to disable the IR receiver on your Tx2?

I have an HTPC and its quite annoying that my Tx2 also reacts when I want to change channel on the TV and so on...

 I dont find it in the device manager to disable it, but I have tried disabling more ore less every other device without an obvious name without success..

I have even tried to find the receiver physically to put some tape over it, without success - maybe there are several!

Discussion:    Add a Comment | Comments 1-2 of 2 | Latest Comment

Generic Member Avatar
Member
April 22, 2010 1:50 PM

There are 2. One on the bezel by the buttons and one on the front by the headphone jack. This one is labeled. I assume there's two so you can use it in either notebook or laptop form.

I would just use electrical tape.

Diane Avatar
Moderator
April 22, 2010 5:36 PM

Try the following:

Disable the eHome Infrared receiver under the USB section
the Consumer IR devices in System Devices
and the MS eHome Infrared devices under Human Interface Devices.

Discussion:    Add a Comment | Comments 1-2 of 2 | Latest Comment

Add Your Reply

(will not be displayed)

Email me when comments are added to this thread

 
 

Please log in or register to participate in this community!

Log In

Remember

Not a member? Sign up!

Did you forget your password?

You can also log in using OpenID.

close this window
close this window