hi
I have a tx2 1012nr and I had to replace the board three times because of issues. Finally I got everything working again except for the fact the back slot for the memory is malfunctioning. The computer throws memory blink codes when any module (i've tried a few) is inserted in the bottom slot. I can ONLY run the computer off of the top slot. I am running win7 ultimate. Could the problem really be the motherboard, AGAIN? Or is there something else I could do to get the bottom ram slot functional?
HP Touchsmart TX2-1012 - Manufacturers Specifications Win 7 Ultimate x64
Take the RAM out of the other slot and try it in the bad slot. Since you know at least one of the RAM modules is working (the one in the top slot) its the best bet for checking the bottom slot.
David
http://i99.photobucket.com/albums/l299/xz550rj/HPMagicGiveaway.jpg
Woohoo! I won my Touchsmart!
I just got the same problem on the same model HP. Top memory slot works fine, but if you put any ram into the bottom slot the computer gives the 3 LED blink code indicating a RAM problem. If I only put 1 ram SODIMM in the top slot everything works.
Suggestions?
Copyright © 2012
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
DVR playground |
Explore3DTV |
MediaSmart Home |
MotoDash |
My Open Router |
Pogoplugged |
DijitCommunity |
Robo Community |
Sansa Community |
TechLore |
TiVo Community |
TouchSmartDevZone
This community site, TouchSmartDevZone.com (including its terms of use, privacy policy and content), is offered by and managed by Capable Networks LLC, not by Hewlett-Packard Company (HP). HP is not responsible for the performance of this community site or for any content posted on the site nor is HP liable for any damages or losses caused or alleged to have been caused by the use this Capable Networks community site. The Community Site is intended for TouchSmart users in the United States and Canada.
Did you forget your password?
You can also log in using OpenID.
Previous Thread
